TubeOhm Instruments

Home
  • DIY hardware
  • Software VST Synthesizer
  • Shop
    • DIY HARDWARE
    • SONIC POTIONS
    • VST SOFTWARE
    • De-Generator
    • Jeannie
  • Forum
  • Contact
  • Impressum

Descent Manual

Controls

1:) Decay Rate

40ms to 5sec (EXP)

80ms to 25sec (LIN)

Adjustable via trimmer on the back

 

2:) Signal LED

Visual representation of the decay signal

 

3:) Trigger/Gate Switch

UP: Decay is triggered immediately by a rising edge on the gate jack

Down: Envelope stays high while the GATE signal is high. The decay phase starts when the gate signal goes low.

 

4:) Gate signal input

Channel 1 jack is normalized to channel 2

 

5:) CV inputs for the decay rate (5V)

 

6:) Output

Envelope signal output (0 to 8V)

Decay behaviour settings

 

The shape of the envelope curve can be adjusted with 2 trimmers on the back.

The times given in the table are just approximate values, since due to component tolerance they may vary a bit.

If you feel the times should be longer, you can increase the value of the 2.2uF capacitors, for shorter times decrease it.

Shop Service

 Hotline

 Information

national:02368 57164

Contact
About us

international:0049 2368 57164

FAQ
AGB
Datenschutz
Widerrufsrecht